Caple C710G Manual de usuario descargar pdf (Pagina 10)

MAINTENANCE

Lubricating the taps

In case of tap hardening, it is necessary to

disassemble and grease it.

These are the operations to carry out:

- Unscrew the two screws that lock the head

flange of the tap.

- Lift the gas adjusting cone and carefully clean it

with gasoline or diluent.

- Spread a little high-temperature grease on it,

making sure that the gas holes are not

obstructed.

- Reassemble all of the parts with care.

Replacing the power supply cable

If the power supply cable should be replaced, it is

necessary to use a cable with a section of 3 x 0.75

mm2, type HO5VV-F or H05RR-F, complying with

the regulations in force.

The connection to the terminal board must be

effected as shown in fig. 9:

brown cable L (phase)

blue cable N (neutral)

green-yellow cable (ground)

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

Caple C710G Manual de usuario Pagina 10