Caple C813C Manual de usuario descargar pdf (Pagina 16)

STEP 10 (See Diagram 10 & Cable Loop Diagram)

A.) Plug one ∅1/2” Plastic Bushing (#76) into the hole on the side of the Rear Vertical Beam

(#4) from the bottom up. Insert the “long bolt end” of the 72 ½” Power Booster Cable (#33)

into the hole. Slide a Spring (#86) and Spring Sleeve (#85) onto the Bolt. Secure it with a ∅

¾” Washer (#114) and M10 Aircraft Nut (#112).

B.) Pull the Cable upward to the Power Booster Frame (#15). Install a Pulley (#79). Secure it

with a M10 x 1 ¾” Allen Bolt (#99), two ∅ ¾” Washers (#114) and one M10 Aircraft Nut.

C.) Draw the Cable over the Pulley downward towards the bracket on the Base Frame (#1).

Install a Small Pulley (#78). Secure it with one M10 x 2” Allen Bolt (#98), two ∅ ¾” Washers

(#114), one 2 3/8” L-shaped Bracket (#83), and one M10 Aircraft Nut (#112).

D.) Continue pulling the Cable to the left towards the bottom of the Weight Stack. Install another

Pulley (#78). Secure it with one M10 x 1 ¾” Allen Bolt (#99), two ∅ ¾” Washers (#114), and

one M10 Aircraft Nut (#112).

E.) Pull the Cable upward and screw it into the bottom of the Selector Rod (#16). NOTE: The

Screw only needs to go into the Rod by ½”. After a period of time using the machine, the

cable will get loose. When the Cable gets loose, screw the bolt further into the Rod.

DIAGRAM 10

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Caple C813C Manual de usuario Pagina 16