Caple C602E Manual de instalación descargar pdf (Pagina 16)

Revision 1.9 - 16 -

5.1.1.2

Installation with slide rail mounting fixture

14.29"

12.10"

10.29"

1.49"

2.95"

0.68"

1.45"

3.00"

14.39"

14.29"

3.00"

1.50"

4.00"

Figure 9 ILFP slide rail mounting fixture

1) Build two (2) mounting fixtures like shown in Figure 9. Use 3”x3”x.25” tubing.

Assure that the holes are in EXACT location as otherwise the slide rails will be off and the gate

might not work properly.

2) Slide the two 3” tubes into the slide rail and locate the correct position with the 3/8” stop bolts.

3) Connect the slide rails to the mounting fixture by using (2) 3/8” bolts and nuts.

4) Slide the assembly over the rear sill of the truck and clamp down the mounting fixture so that the

slide rails facing straight forward towards the cabin.

5) Tag weld the rail support angles to the tuck body longrail and the gate slide rails

6) Check for parallel running slide rails before fully welding the angles to the truck and gate rails

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Sin comentarios

Caple C602E Manual de instalación Pagina 16