Caple C602E Manual de instalación descargar pdf (Pagina 6)

Revision 1.9 - 6 -

Important Notes:

1. Review lift gate invoice and packing slip to assure delivery of correct gate and complete

delivery of accessories and optional equipment

2. Read Manual completely before beginning any work

3. Mount fixture may be ordered separately

4. Refer to your truck/trailer manufacturer’s instructions before adding any auxiliary equipment.

5. Pay Special attention to items marked with this symbol:

6. All welding must be performed by qualified personnel per AWS standards

7. Always ground as close as possible to the welding point to prevent arcing through moving parts

8. Contact PALFINGER Liftgates for Special Installations not covered in this Installation Manual

9. Do not paint cylinder shafts or nylon rollers (Use non-chlorinated brake cleaner to remove

over spray)

10. Final Check-Off-Sheet at the end of this manual MUST be filled out and kept in your records

for future reference and warranty consideration

11. Refer to owner’s manual for lubrication, preventive maintenance, troubleshooting & repairs.

Important Dimensions:

(Refer to line drawing on following pages)

1) BED HEIGHT Bed Height Ranges: Max=Unloaded / Min=Loaded Truck

- Measure from top of body floor to ground. Vehicle must be on flat level ground

2) MOUNT FRAME CLEARANCE

- Measure from BACK of truck/trailer to spring/tire or air suspension components that can interfere

with the liftgate installation

3) REAR SILL HEIGHT and DESIGN

- Measure top of floor to bottom of buck plate and verify design regarding to

Figure 1

Important!!!

The basic rule for installing an ILFP PALFINGER Liftgate is to MOUNT THE FRAME AS HIGH AS

POSSIBLE

to achieve MAXIMUM GROUND CLEARANCE and MINIMIZE THE “F” DIMENSION.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Sin comentarios

Caple C602E Manual de instalación Pagina 6