Caple CAFF21 Manual de usuario descargar pdf (Pagina 13)

CONNECT THE SYSTEM TOGETHER

Connect all of the matching connectors in the system. The con-

nectors are designed so that you can’t get it wrong. Each con-

nector has a unique mate and will only plug into that one.

STEP 1: It’s a good idea to connect all of the connectors with-

out worrying about routing the cables and do a quick check to

see that the system is working. Do this by momentarily and

gently pressing the throttle with the system on, all cables away

from rotating components, and the rear wheel off the ground.

STEP 2: This step requires a bit of craftsmanship to get a

neat installation. Unplug the connectors from step 1. Then-

carefully route each cable so that it does not interfere with any

mechanical component and gives a neat appearance. Your kit

includes a bundle of cable ties for this purpose. Once you’re

satisfied with the cable routing, re-plug the connectors.

STEP 3: At the end you will likely have a bundle of extra loose

wire and connectors. These can be pressed

against your frame and secured with cable ties

as shown in Photo 22.

STEP 4: Your kit comes with a fabric wrap

that can be used to cover the cable bundle.

Photo 23.

Below is a list of all of the connections in the

system. If you want, you can go through the

list and connect each connector in sequence.

Motor Phases. Heavy three wire cable from

the motor. Connects to matching connector on

the controller.

Motor Sensors. Small connector coming out

of the motor housing with six terminals. Connects to matching connector on controller. It’s im-

portant that this cable not be within 1/2” (12mm) of the motor phases cable above for more

than a short distance (6” or 150mm). To do otherwise may cause incorrect operation due to sig-

nal interference.

Main Power. Heavy two wire cable from battery. Connects to matching connector on control-

ler. If the optional Cycle Analyst is installed, it connects between these two connectors.

Throttle. Small connector with three signal terminals in a 4 terminal housing. Connects to

matching connector on controller.

Cadence Sensor. Small connector with two rows of two terminals each. Connects to match-

ing connector on controller.

(22) Cable Bundle

(23) Cable Bundle Cover

1 2 ... 8 9 10 11 12 13 14 15

Sin comentarios

Caple CAFF21 Manual de usuario Pagina 13