Caple CAFF21 Manual de usuario descargar pdf (Pagina 9)

STEP 1: Thread two small cable ties through

the small oval holes in the cadence sensor

backing plate on the left side of the unit as

shown in Photo 10. The heads of the cable ties

should be behind the plate.

STEP 2: Thread the cable ties through the

base of the cadence sensor as shown in Photo

11. Pass the ties back underneath the bottom

edge of the backing plate and secure.

Photo 12 shows the installed sensor.

INSTALL THE CRANK SET

Install the left crank arm and the right crank

arm/chain ring assembly. Tighten the nuts se-

curely. Wrap the bike chain around one of the

sprockets. Photo 13.

INSTALL THE MOTOR CHAIN

The motor/gearbox unit drives the crank set us-

ing a 1/4” (6.35mm) drive chain.

STEP 1: Lay the motor chain over the outermost

crank set sprocket and pass it through the gear-

box from the top as shown in Photo 14. You can

reach into the bottom of the gearbox nose and

turn the small sprocket by hand to pull the chain

through the gearbox.

STEP 2: Join the ends of the chain using the included master link. Photo 15A. The master link

consists of a pin assembly, a side plate, and a spring clip. Join the chain ends with the pin

(14) Installing Motor Chain

(13) Installing Crank Set

(15A) Installing Master Link

(clockwise from top left)

(12) Cadence Sensor Installed

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Caple CAFF21 Manual de usuario Pagina 9