Caple CAFF21 Manual de usuario descargar pdf (Pagina 8)

STEP 4: Re-attach the right side ring to the

EMD frame using the bolts, nuts, and washers

removed at step 1 in the previous section.

Tighten bolts and nuts securely.

ATTACH EMD UNIT TO FRAME

A two piece bracket bolted to the top of the

EMD unit’s middle plate is held to the frame

by a band clamp. See photo 9.

STEP 1: Swing the unit up against the frame

and check the the top edges of the bracket are

parallel to the frame tube surface. If not you

can loosen the bolt and nut holding the bracket to the EMD and adjust its position.

You can also attach the bracket to the EMD

middle plate using the other pair of holes for

even more adjustability.

STEP 2: Slip the worm screw housing of the

band clamp into the openings in the bracket.

Insert the free end of the band into the hous-

ing and tighten as shown in photo 9. You can

slip the end of the band into the plastic tube

that surrounds the band as you tighten it for a

neat appearance.

STEP 3: Tighten the left and right lock rings.

The right ring tightens by turning to the left

using an HCW5 bottom bracket tool. The left

right tightens by turning right.

Some kits will have an aluminum ring on the

left that is turned with a pin spanner such as

the one shown in Photo 5. Others will have a

steel lock ring that turns using the HCW-5.

INSTALL THE CADENCE SENSOR

The cadence sensor sends crank speed infor-

mation to the controller. The system will oper-

ate without it, but only at reduced power. In-

stalling it unlocks the full power potential of

the drive and, together with the speed sensor,

enables the cruise control feature.

(9) Installing Band Clamp

(11) Installing Cadence Sensor

(10) Cable Ties for Cadence Sensor

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios