Caple C804C Especificaciones Pagina 147

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 150
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 146
HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier MN/HPOD.IOM
Appendix C Revision 8
C–5
C.3.2 Install the New Fan Assembly
Figure C-3. Install the New HPOD Fan Assembly
To install the new fan assembly, do these steps:
Step
Task
1
Visually inspect the exposed SSPA heat sink for any debris or blockage. Use compressed air to clear
and clean the heat sink as needed.
2
Connect the fan assembly’s circular connectors to the SSPA.
3
Position the fan assembly onto the SSPA. Make sure that you align the assembly properly, so that you
can bolt down the fasteners without any cable or fan interference.
4
Tighten the four captive fasteners where shown previously in
Figure C-2
.
Be sure to use an appropriate screwdriver, such as the one provided
with the SSPA, to avoid damaging the fasteners.
5
Reconnect the HPOD SSPA to its power source.
Vista de pagina 146
1 2 ... 142 143 144 145 146 147 148 149 150

Comentarios a estos manuales

Sin comentarios