Caple C804C Especificaciones descargar pdf (Pagina 34)

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier MN/HPOD.IOM

External Connectors and Pinouts Revision 8

2–8

2.5.2 ‘J6 | COM1’ Connector

The ‘J6 | COM1’ Discrete Control connector is the primary input for controlling and monitoring

the SSPA. It is a 19-pin circular connector, type MS3112E14-19S. The pinout specification is

shown in Table 2-6.

Mating connector: ITT: KPT06J14-19P or MS3116J14-19P.

Table 2-6. ‘J6 | COM1’ Connector Pinout

Name

Description

A RS485_+RX

B RS485_-RX

C RS485_+TX

D RS485_-TX

RS232_RD

Ethernet TX+

RS232_TD

Ethernet TX-

J Aux_Out Not for customer use

K SumFLT_COM

L SumFLT_NO Open when faulted, else tied to Pin K.

M SumFLT_NC When faulted, tied to Pin K, else open.

GND

P ONLINE_Status Not for customer use

+24V

Not for customer use

S Mute Control

When AUX=1, system is muted until this pin is pulled to ground.

At that time, the unit unmutes. See the AUX remote command.

Minor_FLT_COM

Reserved for future use

U Ethernet RX-

V Ethernet RX+

2.5.3 ‘J8 | INPUT SAMPLE’ Connector

The ‘J8 | INPUT SAMPLE’ port connector is a Type ‘N’ female. It provides a nominal –20 dB

sample of the input signal. A calibration label is provided near the connector that shows the

actual coupling values vs. frequency.

2.5.4 ‘J9 | OUTPUT SAMPLE’ Connector

The ‘J9 | OUTPUT SAMPLE’ port connector is a Type ‘N’ female. It provides a nominal -40 dB

sample of the output signal. A calibration label is provided near the connector that shows the

actual coupling values vs. frequency.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 149 150

Sin comentarios

Caple C804C Especificaciones Pagina 34